G26 gen3 issue after mag change
Hi all, first time post here. I was shooting this past weekend and ran in to an issue.
On the first round of a magazine (one magazine in particular if I observed correctly) the trigger would go back but no click or bang. Rack the slide and normal operation through rest of magazine. I'm pretty sure this was just happening with one magazine (for 19) and not the other two I had (one for 26, one aftermarket 33 round) or 1 other I borrowed (for 19). Each reset after mag insertion was achieved by releasing the slide lock lever, not by racking the slide. I have not since gone back to see if racking rather than releasing slide lock would fix the problem. The magazine in question was marked Glock but the print and logo were reversed (one on top on other two, other on top on the one), could be a previous generation mag or a knock-off? I did notice it bulged somewhat when loaded and the others didn't.
My suspicions, in order from most likely to least, are as follows...Magazine, User error (releasing slide lock rather than racking), Striker spring, Trigger spring, unknown
I probably won't have time to test further until this weekend.
Thoughts or suggestions?